MINOLTA-QMS Magicolor 6110 GN Guida Utente Scaricare il pdf (Pagina 158)

Time-of-Day Clock156

Attach the

time-of-day

clock to the

controller

board.

Attention

Make sure that the pins on the time-of-day clock are properly aligned

with those in the receiving socket on the controller board. Damage

to the time-of-day clock and/or controller board could result if the

pins are misaligned.

Locate the time-of-day clock socket on the controller board and the pin

1 notch or printed label.

Locate the pin 1 indicator mark on the top of the time-of-day clock.

This mark may be a notch or a slight depression on one end of the

clock.

Align this indicator mark with the pin 1 notch or printed label on the

controller board.

Gently press down on the time-of-day clock until it’s firmly seated.

Reinstall the controller board.

Gently slide the controller board into the printer’s tracks until it is fully

seated, and then tighten the two screws.

Reconnect all interface cables.

Reconnect the power cord and turn on the printer.

In compliance with UL guidelines, “The appliance inlet is consid-

ered to be the main disconnect device.”

The presence of the clock will be automatically sensed.

IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII

................................................ ........................ ..........

Pin 1 indicator mark

Pin 1 notch/label

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 215 216

Nessun commento

MINOLTA-QMS Magicolor 6110 GN Guida Utente Pagina 158